1·A container leakage is caused by circle welding seam fractures in the course of hydraulic pressure test.
一贮箱在水压试验时环焊缝开裂导致泄漏。
2·The value of stress under hydraulic pressure test shall not exceed 90% of the yield point of the material in test temperature;
液体压力试验时的应力值，不得超过试验温度下材料屈服点的90%；
3·This series of products mainly used in BOP, valves, blowout pipeline, the BOP tools, wellhead equipment and other products of hydraulic pressure test inspection.
本系列产品主要用于防喷器，阀门，防喷管线，内防喷工具、井口装置等产品的水压试压检验。
4·The estimation formula for slit-type buckets maximal pressure intensity is given through analysis and hydraulic model test.
通过分析研究和水力模型试验，提出了窄缝式挑坎最大动水压强的估算式。
5·Design the signal adjust circuit for sensor, and the power amplification circuit for the hydraulic pressure system of test platform and the controller of magnetorheological dampers.
设计出传感器输入输出信号调理电路和试验台架液压激振系统、磁流变阻尼器控制器的功率放大电路。
6·The displacement curve and pressure curve of outputting were got through test, the influences on servo hydraulic system about pressure jump were discussed in detail.
通过试验得到了输出位移曲线和压力曲线，同时较详细地讨论了影响液压伺服系统压力跃变的主要因素。
7·The test pressure shall be within the limits set forth by the Hydraulic Institute.
测试压力应该在美国水利协会规定的范围内。
8·The article discusses the cause of deformation in the hydraulic test of pressure tubing and suggests some solutions on the basis of analysis.
阐述了耐压管水压试验变形的根本原因，在分析的基础上，指出了解决问题的方法。
9·It introduces the interface circuit design of CAN, Procedure of initializing of SJA1000 CAN controller and the design of hydraulic pressure colligation test-bed.
文中介绍了CAN接口电路设计s、JA1000 CAN控制器的初始化流程和液压综合试验台控制系统的设计。
10·The whole insulation joint is in good condition under soil pressure, specified pipeline operation pressure and factory or field hydraulic test.
在土壤压力、规定的管道操作压力和厂内或现场的水压测试下，整个绝缘接头保持完好。